These units command powder or hysteresis clutches and brakes in winding, unwinding and continuous material handling.
Open-loop diameter compensation
At the winding shaft, torque for a given web tension rises as roll radius increases. CTP estimates diameter from shaft pulses, CTW compares feed and winding pulses, and CTD takes a measurement from a diameter sensor. CTA is a current controller and can accept an external command.
Closed-loop tension and integrated units
CTF responds to a measured tension signal. Specify the detector range and roller geometry before configuring feedback. ATT and ATI support batch or individual settings in integrated systems, while ATB accepts external control. Match actuator current, sensor wiring and the applicable CTS setting unit before commissioning.
Catalog models and specifications
| Model | Control type | Output current | Input or configuration |
|---|---|---|---|
| CTA1100, CTA1200 | Constant current | 1.5 A | Manual or remote reference |
| CTA3200 | Constant current | 3.0 A | Manual or remote reference |
| CTA1300 | Digital-setting constant current | 1.5 A | 8-bit command |
| CTA3300 | Digital-setting constant current | 3.0 A | 8-bit command |
| CTP1200, CTP3200 | Pulse count | 1.5 / 3.0 A | Winding-shaft pulses |
| CTW1200, CTW3200 | Pulse ratio | 1.5 / 3.0 A | Winding and feed shaft pulses |
| CTD1200, CTD3200 | Measured roll diameter | 1.5 / 3.0 A | Diameter sensor |
| CTG1200 | Diameter compensation | 1.5 A | Configurable correction and monitoring |
| CTF1200, CTF3200 | Tension feedback | 1.5 / 3.0 A | Tension detector |
| CTF1400 | Tension feedback | 1.5 A × 4 | Four-channel board |
| CTS1120, CTS1220 | Tension setting | — | For CTP |
| CTS1130 | Tension setting | — | For CTF |
| CTS1150 | Tension setting | — | For CTW |
| CTS1160 | Tension setting | — | For CTD |
| ATT, ATI, ATB | Integrated tension units | — | Pulley, actuator and control options |
Product images






