KYOWA lists two tapered roller geometries for curved conveyors. Use MR-T-42 codes for the Ø42.7 mm small end and nominal 900 mm inside radius. The Ø52 mm small-end MR-T-52 is for a nominal 1,100 mm inside radius.
Curve selection
Fixed catalog widths vary by curve geometry and supply class. The table shows catalog-listed standard points. Choose the curve and face width before the motor and nominal speed. Actual rated surface speed is evaluated at the specified diameter and changes with face position along the taper.
Standard tube geometry
The following large-end dimensions apply to the listed standard widths. For an intermediate width or a different curve, use the manufacturer-approved drawing.
Order-code configurations
| Diameter (mm) | Order-code family | Motor code | Catalog supply / variant |
|---|---|---|---|
| 42.7 | MR-T1-42 | B | 100 V class, single-phase |
| 42.7 | MR-T1-42 | Q | 200 V class, single-phase |
| 42.7 | MR-T3-42 | A | 200 V class, three-phase |
| 42.7 | MR-T3-42 | G | 400 V class, three-phase |
| 42.7 | MR-T3-42 | H | 200 V class, three-phase, high output |
| 52 | MR-T1-52 | B | 100 V class, single-phase |
| 52 | MR-T1-52 | Q | 200 V class, single-phase |
| 52 | MR-T3-52 | A | 200 V class, three-phase |
| 52 | MR-T3-52 | G | 400 V class, three-phase |
| 52 | MR-T3-52 | H | 200 V class, three-phase, high output |
Catalog face-width availability (mm)
| Small end (mm) | Inside curve radius (mm) | 100 V class 1φ | 200 V class 1φ | 200 V class 3φ | 400 V class 3φ | High-output 200 V class 3φ |
|---|---|---|---|---|---|---|
| 42.7 | 900 | 500, 600, 700, 800 | 500, 600, 700, 800 | 500, 600, 700, 800 | 600, 700, 800 | 600, 700, 800 |
| 52 | 1,100 | 300 or 400 | 300 or 400 | 300 or 400 | 400 | 400 |
Standard taper dimensions
| Standard face width (mm) | Small end (mm) | Large end (mm) |
|---|---|---|
| 300 | 52.0 | 66.0 |
| 400 | 52.0 | 71.0 |
| 500 | 42.7 | 66.8 |
| 600 | 42.7 | 71.5 |
| 700 | 42.7 | 76.3 |
| 800 | 42.7 | 80.0 |
Product images


